First Floor Signal Plan
-
All signals from the 1st floor studio BSPs and wall plates will terminate in Control Room 108A.
-
Where possible, cables will run under the raised floor.
-
SMPTE cables will terminate to SMPTE fiber (LEMO) 4RU bulkhead.
-
Dante and NDI CAT6 cable will terminate to an Ethernet switch.
-
HD SDI video feeds from camera AUX IO will terminate to patch and patch to Video router.
-
Analog audio feeds from BSPs will terminate to an Audio bulkhead in the equipment rack.
-
​House Reference will terminate to an analog DA card in an OpenGear frame.
​A wall-mounted Broadcast Service Panel (BSP) will be installed in Studios 112, 108, 107, and 105, serving as the primary signal interface with Control Room 108A. The BSPs in Studios 112 and 108 will be equipped with a DMX lighting control splitter, power strip, auxiliary signal I/O, and SMPTE fiber connections. The BSP includes three auxiliary signal I/O connection plates, designated as CAM1, CAM2, and CAM3, outfitted with the following ports:
-
RJ45 Ethernet connection for House Network access.
-
RJ45 Ethernet connection for the NDI Network.
-
BNC HD-SDI video input and output to and from the router.
-
BNC connector for House Video Reference.
​
Additionally, a Dante plate will include two Ethercon ports for integration into the Dante Audio Network, providing connections to a roll-around stage box and an audio meter. An audio snake will also link to this stage box.
​
A DMX plate (studio 112 and 108 only) will provide connectivity for both the studio lighting splitter and a roll-around lighting control console.
​
An audio plate with six XLR connectors supports a 4Ch Intercom and 2 AUX balanced analog audio outputs.
​
Four SMPTE fiber LEMO connections, which will interface with the broadcast studio cameras.
A wall mounted BSP ( Broadcast Service Panel) will be installed in Studio 112, 108, 107 and 105. ​
Signals to and from BSP
Role-around lighting control console.